Workbenches New York NY

I’ve hauled my grandfather’s workbench across snow-covered Appalachian mountains, down narrow stairwells and into a dirt-floored garage that should have been torn down during the Eisenhower administration. I’ve built a lot of good stuff on that bench, but now it’s time to retire the old horse. For starters, the bench is too low for the way I work. And the top is pockmarked with three different shapes and sizes of dog holes. And during the last few years I’ve become fed up with the tool tray. The only thing it seems designed to hold is enough sawdust for a family of gerbils. So I need a new bench, but there’s no way I’m going to spend $1,200 to $1,400 for a high-quality bench from Hoffman & Hammer or Ulmia.

Enter Bob Key from Georgia. He and his son have been building benches using off-the-rack pine for a few years and have even built a website showing how quick and easy this is to do. I was impressed with their idea. So I spent a week reading every book on benches I could find. I pored over the woodworking catalogs. And after a lot of figuring I came up with a simple plan: Build a bench for less than $175.

Believe it or not, I came in 92 cents under budget and ended up with a bench that is tough, sturdy and darn versatile. I made a few compromises when choosing the hardware to keep the cost down, but I designed the bench so that it can later be upgraded with a nice tail vise. However, I made no compromises in the construction of the top or base. You can dance on this bench.

Let’s Go Shopping

OK friends, it’s time to make your shopping list. First a word about the wood. I priced my lumber from a local Lowe’s. It was tagged as Southern yellow pine, appearance-grade. Unlike a lot of dimensional stock, this stuff is pretty dry and knot-free. Even so, take your time and pick through the store’s pile of 12-foot-long 2 x 8s with care to get the best ones possible. You can hide a few tight knots in the top, but with luck you won’t have to.

Here’s the story on the hardware. The bolts, nuts and washers are used to connect the front rails to the two ends of the bench. Using this hardware, we’ll borrow a technique used by bed makers to build a joint that is stronger than any mortise and tenon. The Bench Dog and Wonder Dog will keep you from having to buy an expensive tail vise. Using these two simple pieces of hardware, you can clamp almost anything to your bench for planing, sanding and chopping. The traditional face vise goes on the front of your bench and is useful for joinery and opening cans of peanut butter.

Preparing Your Lumber

Cut your lumber to length. You’ve probably noticed that your wood has rounded corners and the faces are probably less than glass-smooth. Your first task is to use your jointer and planer to remove those rounded edges an...