Sideboards South Bend IN

It’s unlikely you’ll find the “Kentucky Style” listed in any furniture-design textbook, but it’s real. I’ve spent the last 15 years tracking down examples of this 18th- and 19th-century furniture style to study and incorporate elements of it into my own furniture pieces.

Kentucky furniture is less ornate than the pieces produced in the cities of its day, and this befits its frontier heritage. One of the things that sets Kentucky furniture off from other vernacular forms is the inlay that adorns the drawers and legs. While I’ve seen some examples of the Kentucky style with complex inlay designs, most times the inlay is simple and understated.

The furniture itself is usually made using walnut or cherry, two woods that are common in most parts of the Bluegrass state.

I’ve been building the sideboard design shown here for a number of years, and it has been received enthusiastically by my customers – no matter which side of the Mason-Dixon line they’re from. A three-drawer version also is popular, and it is an easy change should you prefer that arrangement.

This sideboard is built using straightforward joinery and requires only 2"-square material for the legs. In deciding which inlay design to use, I pay careful attention to the wood grain, looking for the perfect flow of grain and contour. Just as with the authentic pieces of Kentucky-style furniture built in the 1700s and 1800s, I let hand-carved knobs and inlaid diamond escutcheons add a special flair.

Begin Construction
If you’re interested in making your own version of this piece, I encourage you to try the inlay details. But if the sideboard itself is what you’re after, I’ve offered the article in two sections. The main article shows you how to make the case, while the side-story explains the inlay work.

Start building the case by first marking the legs for the mortise-and-tenon joints in the face frame. These are the only mortise-and-tenon joints in the piece. The back and sides are held in place on the legs using biscuits.

To mark the mortise and tenon locations, measure down 2" from the top of each leg and mark for the top rail. Then measure another 7" down to define the drawer space and the location of the top of the lower rail. Go ahead and measure another 2-1/2" and 4-1/4" from the drawer space. The 2-1/2" mark is the bottom edge of the mortise, while the 4-1/2" mark defines the starting point of the leg taper where it meets the lower rail. See the illustration for details. The legs themselves taper on the two inside faces to 1" square at the foot. You should cut the taper prior to assembly using either a band saw or table saw.

The mortises are 3/8" x 1-1/2" long x 1/2" deep and positioned so the front frame pieces are flush to the front of the legs. Whe...