Planing New York NY

This excerpt is from the article titled "Four Ways to Make Tapered Legs" from the February 2009 issue of Popular Woodworking Magazine. To read the other three methods as described by Glen D. Huey, Christopher Schwarz, and Robert W. Lang, grab a copy from the Popular Woodworking Shop or from your local newsstands.

As evidenced by this article, there are multiple ways to taper a leg. And over the years I’ve safely used each of the methods described.  Several years ago, however, while teaching new woodworkers how to taper legs it became apparent that a foolproof and totally safe method was necessary. To that end, I developed the following method that uses a thickness planer and a jig.

Start by selecting a piece of 2x4 dimensional lumber that is about 6" longer than the leg you are going to taper. Flatten the face of the 2x4 using your jointer. Then with the newly flattened surface set against the jointer fence, joint one edge “square” to the face of the board.

Next, go to your thickness planer, stand the 2x4 on its square edge, and plane the unjointed edge until you are removing wood over the entire length of the piece – the final dimensions of the jig are not important.

Once you have completed the jig, do not adjust the planer settings. Now, move on to the leg stock. Follow the steps below to turn that 2x4 into a tapering jig.


1. Leg layout. Once the leg stock is milled to final size, on one of the legs you intend to taper, mark around the leg where you want to start the taper. On the bottom of the leg, mark the maximum depth of cut required to achieve the desired taper.


2. Marking the jig blank. Now lay the leg on the jig so that both the line indicating the start of the taper and the maximum cut line are flush with the edge of the jig. With the leg held in position, trace around the entire perimeter with a pencil.


3. Sawing your pocket. At your band saw, carefully cut along the line you just drew and discard the resulting piece of wood. You should have created a “pocket” in your jig into which you can place the leg. Before leaving the band saw, remove about 1⁄4" of width from the top of the jig that holds the non-tapered end of the leg. This will keep the jig from “grabbing” when later feeding the leg into the planer.


4. Roughing a taper. Place the leg to be tapered in the jig so the bottom of the leg protrudes and the top end is “buried” in the jig. With the band saw set at about 1⁄16" wider than the jig, and starting on the bottom end of the leg, hog off most of the wood to be removed.


5. Two passes for two tapers. For tapering on the second side, rotate the leg then make another pass at the
band saw.


6. Smoothed and completed. Finally, take the rough-cut leg (fit into t...