Bookcases Atlanta GA

If you’ve perused the pages of our sister publication, Woodworking Magazine, you might have seen this piece in the Spring 2005 issue. We dug through the archives to find a fine bookcase, then did a bit of construction modification to allow the design to better fit the “I Can Do That” column. And that’s something you should be on the lookout for as you read woodworking articles or skim the pages of your favorite catalogs. Find a piece you like and see what changes can be made to match the construction to your skill set and tools.

For this piece, we eliminated the complicated shelf joinery, and we adjusted a few sizes to better accommodate the lumber dimensions found at home centers. But by and large, this bookcase is close to our original project and a great piece to build.

For material, you’ll need an 8' piece of 1 x 10 for the sides and one shelf, and a 1 x 10 x 4' for two shelves, the braces and one toe kick.Crosscut the material to the required length, then rip the braces and toe kick.

Add Design to the Sides
The bookcase sides require the most work, so begin at the handle area. Measure down from the top 11⁄4", then square a line across the grain. Also, find the top center of the sides then square a line off the top edge that extends just across the first line.

The next layout step is to grab a compass that’s set for a 21⁄2" radius, position the point of the tool at the intersection of the two lines and mark a half-circle with the flat side parallel with the top edge of the sides. To soften the look, round the sharp corners of the handle area. I used a pair of nickels placed at the corners to establish the radius.

To create the handle opening, use a 13⁄16" bit to drill holes at each corner (the bit closely matches the diameter of the nickels). With the two difficult-to-cut areas done, use a jigsaw to remove the balance of the waste. Insert the blade through one of the holes then cut on the line from hole to hole. After that’s complete, pivot the saw to cut the half-circle line. Stay close to the line, take your time as you cut and slow the blade speed if possible – a slower blade increases your control as you cut. Then clean up your cuts with a file and sandpaper.

Next, make the cutout at the base. This, too, is a half-circle with a 21⁄2" radius. Because you can start the cut from the bottom edge of the sides, there’s no need to drill a hole. Use your j...